Airxcel 9000 Series Manual de instalación descargar pdf (Pagina 12)

SeaMach 24 VDC

Rooftop Air Conditioners

SeaMach 24 VDC Rooftop Air Conditioner Installation Manual 5/2013 Page 12 of 20

approved electrical tape, secure the wire nuts to wires in a workmanlike manner (See Figure 6).

Place the metal control box shield over the thermostat, switch and eld wiring boxes. Make certain G.

that all wires are pushed into the control boxes or laying in the wireway between the thermostat and

switch boxes and will not be pinched by the control box shield. Control box shield is properly installed

when the two holes in the shield are aligned with the two screw holes in the ceiling assembly chute

(See Figure 5).

Raise the ceiling assembly and secure to the mounting frame with 4 provided shoulder screw/spring H.

assemblies. The front two screws should pass through the clearance holes in the metal control box

shield (See Figure 7).

The ceiling assembly shroud is curved to contour to a crowned ceiling. If installation is to a at I.

ceiling and gaps are present on the sides of the shroud, insert the four optional 3/4 inch (19 mm)screws

(provided) through the mounting posts and secure them to the mounting frame above (See Figure 5,

6, & 7 for screw locations).

Pull the fabric duct material through ceiling assembly discharge opening. Peel the release liner from J.

the adhesive strip around the discharge opening. Press the fabric duct material rmly in place around

opening. Cut off excess fabric on inside of ceiling assembly chute with a box knife taking care not to

tear the fabric beyond the adhesive strip.

FIGURE 5 FIGURE 6

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Ed jauzemis 10 May 2025 | 20:58:59

Manual 9000

Airxcel 9000 Series Manual de instalación Pagina 12